V-Series Stirrer PermeGear V-Series Stirrers are made for use with our Franz cells. These units do not have temperature control of any kind. They have aluminum supply manifolds mounted toward the rear that connect to a user supplied water bath and pump or heater/recirculator. All V-Series stirrers run at 120v/60hz/600rpm or 230v/50hz/500rpm. VS-Series Stirrer PermeGear’s new V6-VS 6-station variable speed stirrer provides stirring speeds from 300 rpms to 1200 rpms in 50 rpm increments. It allows for robustness testing of diffusion methods. The new V6-VS shares the same footprint as the V6-CB-01 and V6-CB-02 models. All PermeGear jacketed Franz Cells that fit into the previous stirrers fit into the V6-VS. Connections to a heater/circulator are the same as well. The anodized cell holders and stainless steel finish make it resistant to damage from most spills. The V6-VS is compatible with 90 to 220 volt power sources.

H-Series Stirrer PermeGear H-Series Stirrers are made for use with our Side-Bi-Side cells. All but the H1 Stirrers have aluminum supply manifolds mounted toward the rear, which connect to a user-supplied heater/recirculator. The long horizontal manifold tubes have removable hose barb fittings that allow the water jackets of the diffusion cells to be connected to them with latex tubing. All H-Series Stirrers run at 120v/600rpm or 240v/500rpm. DIFFUSION CELLS MUST BE ORDERED SEPARATELY! H-Series Variable Speed PermeGear’s new H1D-VS single station variable speed Side-Bi-Side Cell stirrer provides stirring speeds from 300 rpms to 1200 rpms in 50 rpm increments. The new H1D-VS shares the same footprint as the H1C and all earlier models. All PermeGear Side-Bi-Side Cells that fit into the previous H1 Series stirrers fit into the H1D-VS. Connections to a heater/circulator are the same as well. The H1D-VS is compatible with 90 to 220 volt power sources. H-Series single Stirrer Our PermeGear H-Series single Stirrers are specialy made for the first use and work with Franz Cells. They can be used with different kinds of cell clamps. So they can also handle one Side bi Side cell, or two Standard Franz Cells. Also you can use the System for two Inline Cells. The Single Stirrer has no Water Supply so your cells as to connect direct to your heater.